NANOTS2017Exhibitors Guideline
Top / NANOTS2017 / Exhibitors Guideline
Please prepare your booth following the instructions below. Venue
Opening Hours
Attention: No exhibition on 8 November 2017.
Exhibitors will be able to access the exhibition area during the following hours.
For security reasons, the exhibition area is closed before and after the opening hours stated above. Installation (Move-In)Ship your materials to the following address arriving from 2 November until 8 November 2017:
Installation can be started at 12:00 on Wednesday, 8 November 2017. Dismantle (Move-Out)Exhibitors should dismantle their equipment or booth until 18:00 on Friday, 10 November 2017. Floor PlanPlease see NANOTS2017/Exhibition Program Booth Configuration and RegulationA flat-top desk (W×D×H: 180cm×60cm×70cm) is prepared for each booth. There are no wall behind the desk. If you want to exhibit posters, panels, or any other sheet materials, either of the following methods should be used:
If you want to use poster boards (a pay option), pleas modify the exhibition information (access URL is shown in emails from symposium secretariat) before 13 October 2017. Electric PowerAvailable electric power supplies are:
When any other voltages are required, please prepare an AC-to-AC converter. The total electric-power capacity in the exhibition room is 32kW. In the case where the total electric-power consumption exceeds the capacity, the exhibitors who use electric power are asked for additional charges of electric wiring. Symposium SecretariatIf you have any trouble with the exhibition, please contact to:
|
[About this site] [Contact] [Access]
Copyrights© 1996-2024 INANOT, All Rights Reserved.